What’s Included
The Full Death Watch Armour Set includes:
- Death Watch Inspired Helmet with Range Finder
- Helmet Greeblies
- Shoulder Armour
- Collar Plate
- Chest Plate
- Iron Heart Plate
- Abdominal Armour
- Left & Right Vambraces (Gauntlets)
- Left & Right Hand Guards
- Butt Plate
- Left & Right Thigh Armour
- Left & Right Knee Armour
- Death Watch Inspired Jetpack
- Jetpack Harness System & Mounting Hardware
Every component is professionally printed in durable PETG and supplied as an unfinished DIY kit ready for post-processing.
Sizing
This armour has been designed to fit an average 6 ft (183 cm) adult male build.
Helmet
- Approximate head size: 23″ circumference
- Can be custom scaled by providing your head measurements when ordering.
Gauntlets
- Wrist opening: 22 cm circumference
- Upper arm opening: 32 cm circumference
- Length: 20 cm
Left Thigh
- Width: 13 cm
- Depth: 4.8 cm
- Length: 21.5 cm
Right Thigh
- Width: 16.5 cm
- Depth: 4.3 cm
- Length: 27.5 cm
Hand Guards
- Width: 8.4 cm
- Depth: 2 cm
- Length: 7.7 cm
Knee Armour
- Internal Width: 11 cm
- Depth: 10.3 cm
- Length: 10 cm
Butt Plate
- Width: 22.7 cm
- Depth: 2 cm
- Length: 10.6 cm
Chest Plate
- Width: 32 cm
- Depth: 6 cm
- Length: 30 cm
Collar Straps
- Width: 4.5 cm
- Depth: 3 cm
- Length: 11.5 cm
Shoulder Armour
- Internal Width: 14.8 cm
- Depth: 10.4 cm
- Length: 18.7 cm
Gauntlet Magnet System
The gauntlets have been designed with integrated magnet slots for a clean, secure closure.
They require magnets measuring:
- 120 mm × 10 mm × 3 mm deep
Magnets are not included.
Materials & Finish
Every component is printed in durable PETG, providing excellent strength while remaining lightweight enough for wearable cosplay.
As this is a RAW DIY kit, all components require:
- Sanding
- Filling
- Priming
- Painting
- Final assembly
Layer lines, support marks and print seams are a normal part of the 3D printing process and are intended to be removed during finishing.
Filament colour may vary depending on current stock.
Need Help Finishing Your Kit?
New to finishing 3D prints? Check out our FAQ section for helpful tips and tricks on achieving the best finish for your DIY kit, including advice on sanding, filling, priming and painting.
Please Note
- This is an unfinished RAW 3D printed DIY armour kit and is not supplied painted or assembled.
- The completed armour shown in photographs is for illustration purposes only.
- Visor materials, magnets, electronics, LEDs, batteries, adhesives and finishing supplies are not included unless otherwise stated.
- The helmet can be custom scaled if measurements are provided during ordering.
- Each armour set is printed to order. Please allow sufficient production time for printing, quality inspection and careful packaging before dispatch.
This physical DIY kit is produced from the outstanding design by Alexander Makes under commercial licence.
This is a fan-made prop inspired by the Star Wars universe and is not affiliated with, endorsed by or associated with Lucasfilm Ltd., Disney or any of their respective affiliates.
Reviews
There are no reviews yet.